Probe-type time-of-flight momentum and energy mapping system

A new time-of-flight (TOF) momentum and energy mapping system is proposed. The system consists of two sub-regions with different axial uniform decelerating field. Two position-sensitive detectors (PSDs) on opposite side of the tube are used for the detection of electrons with different axial motion length due to their initial energy ? and emission angle θ. A non-monotonic dependence of energy-resolving performance on electron initial energy can be achieved by choosing appropriate electric field deceleration for these two sub-regions, which forms an “energy resolution probe” possessing a higher level of energy resolution than that of lower energy part. And the local resolution in the probe region could be specifically enhanced while the other parts of all the detection range do not change so much. It is verified by the illustrating example with relative energy resolution Δ?/? smaller than 0.5% for electron energy in probe range from 36 eV to 45 eV.     

基于测试线法的风轮近尾迹辐射噪声研究

在风洞开口实验段,针对不同尖速比应用BSWA VS302USB振动噪声采集分析系统对水平轴风力机叶尖下游4个角度的测试线进行噪声测试.叶尖辐射声中的主要成分是叶片的旋转谐波声,其向风轮下游传播的过程中迅速衰减.在各测试线上,随着测点向风轮下游移动,叶轮辐射声迅速衰减,并在一定距离之后低于背景声,尖速比越高,风轮下游辐射...     

Design studies on the 4π γ-ray calorimeter for the ETF experiment at HIRFL-CSR

A high detection efficiency calorimeter which is used to detect γ-rays with energies from 1 MeV up to 10 MeV as well as light charged particles has been proposed. Design of the geometry, results of the crystal tests and Monte Carlo simulations are presented in this paper. The simulation results confirm that the calorimeter can obtain high detection efficiency and good energy resolution with the current designed geometry. And the calorimeter is competent for the future External Target Facility (ETF) experiments.     

Preparation of a silicon micro-strip nuclear radiation detector by a two-step annealing process

The annealing process for boron implantation is a crucial step during large size nuclear radiation detector fabrication. It can reduce the lattice defects and the projection straggling. A two-step annealing process for boron implantation was developed instead of a one-step annealing process, and the reverse body resistance of a silicon micro-strip detector was significantly increased, which means that the performance of the detector was improved.     

Study of radiation background at the north crossing point of the BEPCⅡ in collision mode

Understanding the radiation background at the north crossing point (NCP) in the tunnel of BEPCII is crucial for the performance safety of the High Purity Germanium (HPGe) detector, and in turn of great significance for long-term stable running of the energy measurement system. Therefore, as the first step, a NaI(Tl) detector is constructed to continuously measure the radiation level of photons as background for future experiments. Furthermore, gamma and neutron dosimeters are utilized to explore the radiation distribution in the vicinity of the NCP where the HPGe detector will be located. Synthesizing all obtained information, the shielding for neutron irradiation is studied based on model-dependent theoretical analysis.     

超导纳米线单光子探测器

利用磁控溅射、电子束光刻和反应离子刻蚀等微加工技术,开展了超导纳米线单光子探测器(SNSPD)的研究.通过对SNSPD的设计和制备工艺参数的优化,成功制备出了高质量的SNSPD.单光子检测实验表明,制备的SNSPD对660 nm波长的光信号,系统检测效率可达30%,对1550 nm波长光信号,最大系统检测效率为4.2%.在平均暗计数小于10 c/s的情况下,系统检测效率大于20%(660 nm)和3%(1550 nm). 关键词： 单光子 氮化铌 纳米线 探测器     

水平层状介质中电磁场并矢Green函数的一种快速新算法

本文利用提取直射波并结合自适应数字滤波等技术提出一种计算水平层状介质中电磁场并矢Green函数的快速算法. 首先将谱域Green函数中表征均匀介质作用的直射波提取出来并对其积分进行解析计算,这种处理降低了谱域Green函数的奇异性,可在很大程度上缩短其积分收敛区间. 然后在将谱域Green函数剩余部分对应积分转化为三个快速下降积分的基础上,引入一种自适应数字滤波算法对其进行快速求解. 最后通过具体算例验证了本文所述算法的有效性. 关键词： 并矢Green函数 快速算法 水平层状介质     

微流控芯片简易安培检测器的制作及对烟酰胺片中烟酰胺的测定

搭建了微流控芯片简易安培检测器,并用于市售药品烟酰胺片中烟酰胺含量的测定。由碳纳米管微圆盘电极和钛管组成集成双电极,中间的碳纳米管微圆盘电极作为安培检测的工作电极,外套的钛管既作为安培检测的对极,又充当分离高压电源的地极,使其结构更加简化和微型化。优化了缓冲溶液种类、浓度,分离电压及进样时间等实验条件。结果表明,在10 mmol·L-1磷酸盐缓冲液(pH 7.8)中,进样10 s,在2.0kV电压下分离,烟酰胺在2 min内可实现较好的分离和检测,其线性范围为10~600μmol·L-1,检出限(S/N=3)为5.0μmol·L-1,相对标准偏差(RSD)为3.0%,平均加标回收率为99.1%。该装置实现了微型化和集成化,并具有检测灵敏度较高、选择性好、成本低等特点,可用于药品的质量控制。     

An overview of analytical methodologies for the determination of antibiotics in environmental waters

The widespread occurrence of antibiotics as contaminants in the aquatic environment has increased attention in the last years. The concern over the release of antibiotics into the environment is related primarily to the potential for the development of antimicrobial resistance among microorganisms. This article presents an overview of analytical methodologies for the determination of quinolone (Qs) and fluoroquinolone (FQs), macrolide (MLs), tetracycline (TCs), sulfonamide (SAs) antibiotics and trimethoprim (TMP) in different environmental waters. The analysis of these antibiotics has usually been carried out by high-performance liquid chromatography (HPLC) coupled to mass spectrometry (MS) or tandem mass spectrometry (MS/MS) and to a lesser extent by ultraviolet (UV) or fluorescence detection (FD). A very important step before LC analysis is sample preparation and extraction leading to elimination of interferences and prevention of matrix effect and preconcentration of target analytes.     

Simple and precise detection of lipid compounds present within liposomal formulations using a charged aerosol detector

In recent decades the use of liposomal preparations as drug delivery systems has become very attractive in pharmaceutical development. Therefore, thorough characterization and quantification of the lipids which form liposomes is wished from both investigators and regulatory authorities when the application in humans is being considered. In this study a new HPLC method for the detection of lipids in liposomal formulations was established using corona charged aerosol detection (CAD) which has the advantage to be independent of the chemical properties of the analytes. The superiority of this method over UV detection was demonstrated. Compared to UV detection no absorption effects of the organic solvent in the mobile phase interfering with the lipid signals were observed with CAD. CAD showed good linearity (R² > 0.990) for all liposomal compounds. The acceptance criteria for precision including repeatability were met. The average recovery for each of the excipients of the liposomal formulation was in the range of 90.0–110%.